This 'Peyote technique' ring can be created by any of you, even if beginners.
The following schemes will allow you to adapt this technique to many other jewels (see the Clover bracelet).

Advice before starting your work :
Do not work with more than 1 meter of thread to avoid knots.
When you change thread, do not make any knot but pass it through the anterior strand, and do the same when finishing your thread before cutting it.
Tighten the threads quite well to ensure a regular weaving.

Step 1 : weaving the bracelet
Create a strip of 6 delica 11/0 DB 1459 (rose) width and 14.5cm long, as shown in the "peyote plat pair" drawing :

Close the loop passing the thread through the opposite beads, to create an invisible weaving. Step 2 : setting the button
Take off the metal loop behind the button so that it will not exceed.
Insert 56 delicas 11/0 alternating the DB 1459 (rose) with DB 1286 (grey), so that the beginners will follow the schemes easier. Weave a "circular peyote" as indicated below :

Finish the setting as indicated on the scheme, with seed beads 15/0 MR15-142FR above and circular peyote under.

Emrboidery :
Decorate the setting with leaves and little points.
Make the leaves with 4 delica 11/0 DB 103, one seed bead MR11-351 and one seed bead MR15-142FR.
Make the small points with 2 seed beads MR11-351 and 1 seed bead MR15-142FR

Now you just need to sew the button on the base and decorate with leaves and pearls.